This chart is to help you remember the key points in operating a HYTORC Tool System

• BEWARE OF YOUR REACTION AREA
• MAKE SURE THAT YOUR HOSE CONNECTIONS ARE TIGHT
• INSPECT HOSES FOR DAMAGE
• MAKE SURE YOU HAVE 25 AMPS TO OPERATE WITH

• MAKE SURE THAT YOU HAVE THE CORRECT TORQUE CHART TO WORK WITH

• ALWAYS SET PUMP PRESSURE STARTING AT LOWER PSI SETTING, THEN INCREASING TO A HIGHER PSI SETTING

• MAKE SURE THE GUAGE RETURNS TO ZERO (0) BEFORE USING

• CYCLE TOOL 3 TO 5 TIMES TO ENSURE THE TOOL IS FUNCTIONING PROPERLY

• CHECK PUMP OIL LEVEL BEFORE USING & SERVICE PUMP EVERY 50 HOURS ACCORDING TO PUMP SPECIFICATIONS

• MAKE SURE TOOL HAS BEEN GREASED

IF YOU HAVE ANY QUESTIONS CONTACT

Your area manager. 

SEND TOOL AND PUMP REPAIRS TO:

HYTORC WEST

ATTN:  REPAIR DEPARTMENT

1944 Lund Road

Bancroft, ID 83217

Office Phone: (208) 648-0897

Fax Number: (208) 648-9970